I tried to reset to factory by selecting RESET DEFAULT DATA option but I get this message THIS RADIO DATA VERSION DOES NOT MATCH THE DEFAULT FILES The radio has firmware A7.00.11.007 bootloader 01.07.002 I have CPS version V7.00.07.017.NA2 The exact radio model is PD782-0000000L-000000-U2-0-B Original firmware from factory was A6.05.07.005 I am not familiar with Hytera software so any help would be appreciated.Copyright 2019 Communications Support Forums.
Hytera Model Settings Do Not Match Software So AnyAll rights reserved. I found the new codeplug here but cannot write it (or clone it) to the radio. How can I overcome this Programming software: ver. NA2. Radio Serial: 13304A0897 (different than the codeplug) Radio Firmware: A6.05.07.006 (different than the codeplug) Thanks for any guidance. This will require you to read the radio afterwards, set the radio ID, they write to the radio. You use this technique when using a code plug that didnt originate on the radio. Read the radio, the copy and paste the configuration information from the new code plug. If that doesnt work let us know, we have some Hytera experts that can probably help out. I noticed that KB6CIOs codeplug seemed to have been written in version 6 of the CPS, and version 6 of the firmware. When I applied the Upgrade CPS Data command (the third from the last item under the Tools menu), it upgraded it to the newest release of the CPS (ver. Trouble is, although I was using ver. CPS, my radio only had ver. Eventually it dawned on me that I should try to upgrade the firmware of the radio to ver. Somewhere in all my Googling I ran across something that said the codeplug is firmware-dependent. I found instructions for the ver. Hytera Model Settings Do Not Match How To Upgrade TheIt includes instructions on how to upgrade the firmware, and how to check the current version of the firmware in the radio to see if it is upgradeable. To make sure I was not downloading something bogus, I checked the Hytera site to match as closely as I could the right upgrade file for the HT. That got the HT to ver. ![]() So, at this point, I wrote the upgraded version of the KB6CIOs codeplug to the radio using the Clone command. ![]() In some cases, I am not sure what the terminology was so I left those portions alone. But I added some analog frequencies, set up a new scan list and a couple of other things (including changing the Radio ID to my own). Tomorrow during the drive to, or while at, work, I will monitor and test it out, and perhaps call somebody as proof of concept. Thanks to you guys for pointing me in enough of the right direction that I could figure it out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |